California State Polytechnic University, Pomona

MECHANICAL ENGINEERING DEPARTMENT

Student Forms and Information

For students wishing to remove a Mechanical Engineering Department registration hold, this form must be completed before seeing your advisor.

This provides guidance on balancing academic loads and work-for-pay.

This is a list of faculty responsible for the content of the various Mechanical Engineering courses.

This is a list of quarters in which the various Mechanical Engineering courses are expected to be offered.

	Request for Course Substitution or Acceptance of Transfer Coursework – College of Engineering.
	This diagram shows all required courses for Mechanical Engineering majors (2006/2007 academic year). For other academic years, please go to the College of Engineering Curriculum Sheets Page or see the Mechanical Engineering department secretary.

This describes the Mechanical Engineering department policy for maintaining good academic standing.

This is a list of prerequisites for all Mechanical Engineering courses.

This provides guidelines and forms for students using work experience in lieu of a traditional Senior Project.

This form must be completed if you want to take two courses whose class schedule overlaps.

This describes the requirements for successful completion of the Senior Project.

This is a list of Mechanical Engineering technical electives and a form that must be approved by your advisor.

Follow this link for a list of Faculty Office Hours.

Faculty advisors are assigned based on the first letter of the student's last name; however, students that are subject to disqualification must see one of the "Subject to Disqualification" advisors. All advisors are members of the Mechanical Engineering department faculty and are listed in the table below. Office hours for the current quarter can be obtained by following the link above, by phone, or by looking at the posting on the bulletin board outside each faculty office.